HEATIT 4512495 - Heating controller for water heaters, Z-Wave

Z-wave controller 868.4 MHz

Heatit Z-Water2 is a DIN rail controller for controlling water-based heating systems. The module clips directly onto a DIN rail and allows you to control your water-based heating system through your Z-Wave network. Heatit Z-Water2 is equipped with 9 potential-free relays for actuators. It also has 2 analog inputs for temperature sensors.

• Controller for water-based heating systems
• 9 potential-free relays Valve actuation
• Can control 230VAC actuators and 24V actuators from an external power supply
• IOT protocol: Z-Wave - 868.4 MHz (EU)
• Range: up to 40m
• IOT chip type: Z-Wave 800 chip

The Heatit Z-Water2 relays can be controlled by associations with other Z-Wave thermostats e.g. Heatit. Each relay can control one or more actuators in your heating system.

Flexible operating modes for different heating systems
In addition, the Heatit Z-Water2 supports various operating modes for flexible adaptation to different heating systems and installation requirements. Configuration is conveniently carried out via the respective Z-Wave gateway, allowing heating times, temperature limits and control logics to be managed centrally.

Optimized for installation in the heating distributor
Thanks to its DIN rail mounting, the module is particularly suitable for use in distribution boxes for underfloor and water-based heating systems in residential and commercial buildings. The potential-free relays enable the safe operation of common 24 V and 230 V actuators.

Expandable through smart home automation
By integrating it into a Z-Wave smart home system, the heating control can also be linked to other automations, such as time schedules, presence control or energy-saving functions.

Further functions:

• Can be used with Heatit thermostats in any heating zone, DIN rail mounting
• Connection for external antenna
• SmartStart
• Firmware update (OTA)
• Supports encryption mode S0, S2 Authenticated Class, S2 Unauthenticated Class

...