HEATIT 5430566 - Thermostat, Z-Wave, RAL 9003

Z-Wave thermostat 3600W 16A 868.4 MHz

Intelligent thermostat. Heatit Z-TRM6 is an electronic thermostat designed for electric heating and water heating. The thermostat can be controlled via your Z-Wave network or via the buttons on the front of the thermostat. The thermostat has a user-friendly interface, complies with the Eco Design Directive and has an easy-to-read LCD display.

• Internal room sensor
• External room sensor (with cable)
• Floor sensor
• ZeroX™ technology
• Power controller
• IOT protocol: Z-Wave - 868.4 MHz (EU)
• IOT chip type: Z-Wave 800 chip

The thermostat fits into standard European junction boxes and can be used with most System 55 frames. It has a sturdy metal frame for secure mounting in the junction box. The thermostat has a built-in room temperature sensor. Two additional external temperature sensors can also be connected.

3 different modes:

• Heat
• Cool
• Eco

Active power measurement with manual calibration
Heatit Z-TRM6 has an active power measurement and gives you real-time information about the power consumption. It also allows you to set the power measurement value manually in the event of a connection to a contactor.

ZeroXTM technology
The device is equipped with ZeroXTM technology, which ensures the relay switches at 0V when switching on and off. This technology significantly extends the service life of the thermostat.

Master thermostat with extended associations
The thermostat can be set up with multiple associations and can be used as a master thermostat. It can control up to 10 thermostats and 10 external relays, e.g. wall plugs.

Electrical load compatibility
The thermostat is specially designed for resistive loads. When controlling large resistive, capacitive or inductive loads, it is important to use a suitable contactor to protect the thermostat from excessive loading to ensure safe operation.

High load capacity up to 16 A / 3600 W
The thermostat can withstand a resistive load of up to 16A/3600W at 230VAC.
Note: For loads over 13A, the use of a contactor is recommended.

Further functions:

• Hysteresis/PWM Temperature calibration
• Open window detection
• ZeroX detection
• Relay status symbol
• Adjustable display brightness
• Single pole switch
• Lock mode/child lock
• Active power measurement
• SmartStart
• Supports the encryption modes S0, S2 Authenticated Class, S2 Unauthenticated Class
• Intrinsic power consumption (watts): 2
• Effect controller:Timed cycle 0-30 minutes
• Hysteresis:0.3 to 3.0 (standard hysteresis 0.5)
• Switch type: Single pole switch
• Compatible NTC sensors (O @ 25°C):10,... ...