TESA 50378 - TESA fine dust filter, size S, 100x80 mm

The tesa Clean Air® fine dust filter for laser printers, fax machines and copiers ensures clean air in companies, public authorities, the office and at home. The new tesa Clean Air® fine dust filter is made of environmentally neutral, fully recyclable nonwovens. Thanks to its three-layer structure and additional electrostatically charged microfibers in the middle layer, even respirable fine particles are permanently bound - regardless of the specific chemical composition of the emitted fine dust.

Product description

retains up to 94% of all fine dust particles

Permanent retention of the finest particles thanks to three-layer filter (micronAir technology)

high air permeability ensures unrestricted functionality of the printer

Easy to attach and replace thanks to Velcro system

Can be easily disposed of with household waste

Capacity: up to 70,000 pages or 12 months

Dimensions

• Size S 100 x 80 mm

Product description

The problem: fine dust is harmful to health
Many people are certainly not aware that fine dust from laser printers can cause considerable damage to health. In some offices, the indoor climate is more polluted than on a busy highway. However, compared to fine dust emissions from cars, the particles are smaller and can settle in the lungs or bloodstream.

The solution: tesa Clean Air®
Thanks to the cooperation between tesa® and the filter manufacturer Freudenberg Filtration Technologies, there is now tesa Clean Air®, the effective fine dust filter for laser printers! The filter retains up to 94% of fine and ultra-fine dust and thus reduces the health risk. TÜV Nord has certified the effectiveness of the filter and confirms protection against fine dust and toner dust. Our ''Filter Advisor'' will tell you whether tesa Clean Air® is also available for your printer!

Structure
The printer filter is made of environmentally neutral, recyclable nonwovens. Three layers ensure that the finest dust particles are filtered out. The first layer is a pre-filter made of microfibers for separating coarser fine dust. The middle layer of electrostatically charged microfibers takes care of the smaller particles and the third, extra-fine layer takes care of the smallest particles.

Use
Small effort, big effect!

1. Clean the area around the exhaust air slot so that the surface is free of dust, oil and release agents.
2. Remove the protective film from the adhesive tape and press the filter firmly onto the dry surface. The printer filter should completely cover the exhaust air slot.
3. Remove the filter, press the Velcro strips firmly onto the printer and attach the filter to the Velcro strip. For maximum adhesion, the filter must not be removed from the printer for 24 hours.

...