FORMLABS FORM 3 TANK V2.1 - 3D pressure, form 3, resin tank V2.1

The resin tank V2 for the form lab form 3 is the tank in which the printing material (resin) is located. Compared to form 2, some improvements have been implemented. The tank now holds a larger resin volume, which means that it can no longer overflow and spill. In addition, the form 3 resin tank has a new flexible PDMS layer. This layer is comparable in terms of its service life to that of the LT tank of the predecessor model and thus lasts extremely long.

When handling it is important to keep in mind that the pressure surface of the tank is not touched with sharp or sharp objects, otherwise scratches, defects or contamination may occur.

The form 3 resin tanks are supplied in combination with a resealable storage box. This box is used to store the resin tanks. In addition, you will of course also receive a wiper for automatic refreshing of the resin. Similar to the predecessor model and comparable printers, we also recommend storage outside direct sunlight and the use of a resin tank for each printing material.

Despite the long-lasting PDMS layer, it is a consumable item that needs to be replaced at regular intervals depending on the print volume.

Differences between resin tank and resin tank V2 forming labs:
Only version 2 is compatible with the resins Elastic, rigid, Castable Wax 40 and Gray Pro. The version 2.1 can be identified by a small sticker on the left rear of the tank or in the display of the form 3 and form 3B. ...