APC BE650G2-GR - Back UPS, 650VA, 230V, USB

APC Back-UPS 650VA, 230V, 1 USB charging port
Battery Backup & Surge Protector for Electronics and Computers

Output

• Output power capacity: 400Watts / 650VA
• Max Configurable Power (Watts): 400Watts / 650VA
• Nominal Output Voltage: 230V
• Efficiency at Full Load: 80.0 %
• Output Frequency (sync to mains): 47 - 63 Hz
• Output Frequency (not synced): 50/60 Hz +/-1 Hz
• Other Output Voltages: 220
• Topology: Standby
• Waveform type: Stepped approximation to a sinewave
• Output Connections: (2) F CEE 7 (Surge Protection), (6) F CEE 7 (Battery Backup)
• Transfer Time: 6ms typical : 10ms maximum

Input

• Nominal Input Voltage: 230V
• Input frequency: 47 - 63 Hz
• Input Connections: F CEE 7/7P
• Cord Length: 1.83meters
• Input voltage range for main operations: 180 - 266V
• Efficiency at Full Load: 80.0 %
• Maximum Input Current: 6.0A

Batteries & Runtime

• Battery type: Maintenance-free sealed Lead-Acid battery with suspended electrolyte : leakproof
• Expected Battery Life (years): 2 - 5
• Battery Volt-Amp-Hour Capacity: 75

Communications & Management

• Interface Port(s): USB
• Control panel: LED status display with load and battery bar-graphs and On Line : On Battery : Replace Battery : and Overload Indicators, LED status display with On Line : On Battery : Replace Battery and Overload indicators
• Audible Alarm: Alarm when on battery : distinctive low battery alarm : overload continuous tone alarm

Surge Protection and Filtering

• Surge energy rating: 310Joules
• Data Line Protection: Analog phone line for phone/fax/modem/DSL (RJ-45 connector), Network line - 10/100 Base-T Ethernet (RJ-45 connector)

Adjustable voltage sensitivity
Provides the ability to adapt the UPS for optimal performance in specific power environments or generator applications.

Automatic self-test
Periodic battery self-test ensures early detection of a battery that needs to be replaced.

Battery failure notification
Provides early-warning fault analysis on batteries enabling timely preventive maintenance

Building Wiring Fault Indicator
This LED informs users of potentially dangerous wiring problems in the wall circuit.

Cold-start capable
Provides temporary battery power when the utility power is out.

Dataline surge protection
Provides protection of connected equipment from power surges on the data lines.

Disconnected battery notification
Warns when a battery is not available to provide backup power.

Hot-swappable batteries
Ensures... ...